
There was a 4 story fall directy to my left, so I held onto the light poll and took the picture...Keepin' it safe!
I don’t know about the rest of you but the turn of the new year always gets the internal fire lit knowing that spring motorsports are almost here. I have been concocting a few inexpensive improvements to Minty Smash lately in prep for this years Kansas YEAH! events.
Upgrade Brake Fluid (higher temp or DOT 5.1)
Hood Vent (needs installed)
Ganador Mirrors (need painted and installed)
Hood Spacing at Hinges (stack of washers)
Better Rear Pads and Lines (thanks Steve)
Adjust E-brake
Bucket Seat (probably another knock Bride)
Harness Bar (have belts already and ability to bend bar)
Steering Wheel Hub Extension
1000cc Injectors
Another Walbro or larger Bosch Fuel Pump
E85 Fuel
Re-tune
Wire in Push Start (to help clear fuel from cylinders after spin, no more push starts)
Wire in Fuel Pump Switch (also to help clear fuel from cylinders after spin, no more push starts)
I will amend the list if more comes to mind, but for now this is it. Won’t break the bank and effective!
Joe Bob
Sounds like a sub 500rwhp build, not good enough.
Brickhouse Products
The turbo is only good to 450hp I think so this has never been about a 500hp car. The goal my brother laid out for the engine was 400hp and I would like to see it get there. And definitely it needs to be above 300hp. Right now 280hp is like piddly little kiddy poo compared to what it was built for.
Joe Bob
I know what the turbo is capable of lol. I’m also well versed on ka’s. I’ve changed the oil on one once.